Instructions for adjustment of RCS and RCS corsacorta Master Cylinder

1. Check the lever ratio value, verifying, with the master cylinder mounted on the vehicle, the colour of the top surface of the push rod (point 3).

3. Rotate the lever-handlebar distance adjustment knob anti-clockwise (point 6) all the way to reveal the ration adjustment groove (point 5) inside the hole (point 7).

4. If remains of dirt or foreign material are present inside the hole (point 5), clean with a damp cloth.

5. Use a flat-blade screwdriver (point 8) with tip (point 9) measuring 3mm MAX, 2 mm MIN; this measurement must be observed for a length of 12mm MIN.

WARNING! To avoid damaging the internal parts and compromising correct operation of the product, do not use a screwdriver different from the one specified.
The use of a screwdriver different from the one specified is considered installation contrary to the Manufacturer’s directions, in which case BREMBO will not be liable for any damage caused to and/or by any person using a vehicle on which the product has been installed.

6. Fit the flat-blade screwdriver (point 8) into the hole (point 5) until it engages the groove (punto 7).

WARNING! During adjustment with screwdriver, do not exert excessive force, either in rotation or under pressure, to avoid damaging the internal parts.

7. Rotate the screwdriver by 180° until you hear the click indicating that the selection has been made; check that the colour of the push rod (point 3) corresponds to the desired ratio value.

8. Reposition the rubber cap (point 4) on the lever and rotate the lever-handlebar distance adjustment knob (point 6) until the lever is positioned (point 2) at the desired distance from the handlebar.

WARNING! Adjustment of the ration affects the lever travel in generating the pressure necessary to stop the vehicle.

CAUTION! The “RCS corsacorta” master cylinder can be distinguished by the ”corsacorta” marking (point 10).

WARNING! Adjustment of the idle stroke to one of the three settings R-S-N via the knob (point 11) affects the lever stroke in generating the pressure necessary to stop the vehicle.

WARNING! For all the adjustments described above, make sure that when the lever is engaged, it can rotate to generate the correct braking action; otherwise, operate the knob (point 6) to move the lever away.

This warranty covers all the conformity defects occurring within two years from delivery of the good. The consumer is required to report to the seller the conformity defect within two months from the date of discovery of the said defect, without prejudice to the fact that the limitations period for taking action aimed at seeking redress for the defect is twenty-six months from delivery of the good. In the event of a conformity defect, the user has the right to repair or replacement of the good, or to an appropriate price reduction or termination of the contract, as established by art. 130 of the Consumer Code, where applicable.

This warranty constitutes the only warranty provided in relation to this product and replaces any other warranties, both verbal and written.